Posted for Sam Welch. Sam can tell you more - but this an amazing project. The ornament is of "German" silver and is about 4 inches high. It was made from a belt buckle blank.
Earlier posts show the shift lever to the car. And you thought a Winchester lever action had a lot of surface area!
Good work Sam!

Bill Gamradt
6/16/2006 11:46:46 PM

Thank you for sharing some more of your amazing work, Sam.
Just outstanding!
Best regards, John.

John Barraclough
6/17/2006 2:00:41 PM

Hi Sam

That's beautiful. So when does the engraving start on the bodywork !!!

Best regards
Andrew Biggs

Andrew Biggs
6/19/2006 5:39:49 PM

Andrew, I am still looking for a large enough graver! Actually, there is a good bit of engraving on dash and engine parts and there are a lot of stainless carriage bolt heads that will be worked on also. Thanks for the comment. Regards...

Sam Welch
6/19/2006 6:57:14 PM